Why a Static Lie Angle Reading Lies to You
The number stamped on a bench gauge and the number your club actually presents at impact are rarely the same. Here's the gap, and why it matters more for some golfers than others.
Read the article →
Journal
The Loft & Lie Journal
Short, practical write-ups from the gauge bench — what dynamic measurement actually shows once a club is moving, and why the static numbers on a spec sheet only tell part of the story.
How Marine-Layer Humidity Changes Grip and Shaft Feel
Bellingham's marine air does something specific to grip tack and shaft perception across a single round. Here's what to expect and when to check your equipment for it.
Read the article →Loft Creep: What a Decade of Mis-Hits Does to Your Irons
Forged and cast heads both bend more than golfers expect over years of range sessions. Here's how to tell if your set has quietly drifted off its original spec.
Read the article →Reading Impact Tape for Lie Angle Clues
A strip of impact tape and a lie board can tell you more than most golfers realize before they ever book a session. Here's how to read the marks correctly.
Read the article →Glacial Till Fairways: Why Whatcom County Turf Plays Firm
The soil under most Whatcom County courses compacts differently than the sandy loam most national fitting charts assume. Here's what that means for sole and bounce choices.
Read the article →Posture Changes What Lie Angle Actually Reads
Two golfers with identical static specs can need opposite lie angle corrections once posture enters the picture. Here's why the gauge bench alone can't catch it.
Read the article →Put a Reading to the Test
Reading about the gap between static and dynamic numbers only goes so far — seeing your own readings on the bench is a different kind of convincing.